Sorryfor the long winded responses I have been providing, not that good at thisforum stuff.
Hereis another side note; the windshield manhad put the top down to make it easier to replace the windshield. At some point a “large roll of tape” was on theleft rear folding wing. The glass manmade an attempt to put the top up so std tape could be used to hold thewindshield in place. However, when thetop was being put back up, the roll of “protection tape” fell down into thelinkage/levers and brackets resulting in a $6K dealer repair to the topmechanisium. Of course the glass mandenied anything to do with it until I provide vedio of what happened. The glass man reluctenly paid the bill. After the top was working again, the glassman tried to correct the leak several times; used the foam/air trick,removed/inspected/resealed windshield. Everyonewas confident that the windshield to sealant to frame was good and not thesource of the leak. But we still had theleak that starts at the very top corner of both A pillars. Then I flooded the top control while tryingto pin pint the leak source my self. Glassman said they couldn’t properly troubleshoot the leak until the top wasfixed. It has taken over a year to getthe parts/info/time for me to get the top working again. The glass man still has a bad taste over the$6K bill they had to pay so getting them involved a year later is notlikely. I feel they are not “competent”enough to really troubleshoot and diagnose the leak problem anyway. I pretty much took over the windshield leakjob. Had several friends look at theparts/seal/gasket area and they too don’t understand how the water at the topseal is supposed to get to the drain. Ifeel that the original windshield and a seal/gutter type part that was notremoved and put on the new GM stamped windshield. Iguess I will have to post some pictures to fully explain what I am trying tosay. To make matters worse (maybe better!?!?!?) thecurrent windshield just got a bad chip/crack. Plan to have a GM dealer that does a lot of Corevette windshileds makethe repair. Maybe they can resolve this.
PS;will be able to get access to a Tech II last updated 2010.
